Enter schematic wiring mode.
Wire [/start] [/loc <x1> <y1> <x2> <y2>] [/mode] [/startloc <x1> <y1>]
|
/loc |
If specified, command in non-interactive and wire is placed at location specified by x1 y1 x2 y2. Co-ordinates are relative and would usually be derived from a call to WirePoints . |
|
/mode |
If specified, the schematic editor is placed in a temporary wiring mode. The next left click will start a wire and wiring may proceed in the usual manner. After pressing the right mouse button, wiring mode will be cancelled. |
|
/start |
If specified, a new wire is started. |
|
/startloc |
|
| ▲ Command Summary ▲ | ||
| ◄ WebOpen | WireMode ▶ | |